Embedded Files
2022-03-17
First, when i start to study about 3D printing (with budget, of course) 'Creality' always pop up.
I'm conclude to 2 model, 'Ender6' and 'CR200B'. While 'Ender6' had been review about delivery damaged problem and 'CR200B' had been review about 'extruder heat problem', but some already said, they don't have that problem, so i end up with 'CR200B' and yes, that problem already solved.
They make ventilation near the motor. (and if you saw some 'filament powder' at the extruder, that's mean you might have problem with clogging or step skipping)
First, the most important (for me) is 'bed' leveling
First, the most important (for me) is 'bed' leveling
Problem I had encounter while printing mostly about 'bed leveling', so, check out the first layer and you might notice it right away.(I'm start to looking for 'CR-touch' but still studying)
Print speed
Print speed
I had print with large size model with speed @ 80 mm/s and the 'bed plate' shaking a lot, (very very shaking like crazy, but the printing still work) so I set to 70 mm/s at that print and the result did fine.
But with small model, I had no problem with 100mm/s
I'm very happy with print quality but need to credit to filament too. (right now, just PLA which usually easy to print, so I will write about other filament later.)
I already order 'creality PEI magnetic build plate' (for my ABS print) but end up not to use it, because i need to install the magnetic plate and it will replace the original glass plate, which some already review that both are same good (magnetic PEI and glass). so i just order PEI film sheet.
So, I might write about this after i have my ABS print.
ABS printed are super satisfy, very easy.
I have problem with 'Thermistor Cartridge', the conduct very fragile and easy to break.
Page updated
Google Sites
Report abuse